RMX Parts

Various RMX parts
Qty: 25

Here are various parts used in RMX consoles. We stock cosmetic parts as well as switches, capacitors, faceplates, fader knobs, P&G faders, small and large knobs with knob caps. Anything your RMX needs we have available. The P&G fader assembly is $165.00 each with connector.


Qty: 100

Here is a photo showing the various parts we replace on a regular basis in RMX modules. The module ON/OFF switch is available new at $65.00 each. Our 25-102 rebuilts are $45.00 each.


RMX/ProductionMixer Power Supply kit
Qty: 10

Here is our capacitor upgrade kit for the RMX and ProductionMixer power supply. The instructions take you step by step for a completion time of 2 hours. The 16 Volt bi-polar, 13 Volt logic and Mic Phantom supplies get the correct replacement parts.


25-102 PR&E ON/OFF switch
Qty: 78

Here are two Microswitches. The one on the left is rebuilt by MOORETRONIX. The one on the right is a fresh new Honeywell series 4 microswitch. The one on the left has a new switch with shorter terminals and is $20.00 less than a new one. Seems like a no brainer when you need a replacement. Two year warranty on our rebuilt 25-102 switches.


RMX version VCA control for Control Room
Qty: 60

This module can be field installed into the RMX Control Room module. It replaces the old noisey Headphone and Monitor pots with DC control and superb stereo tracking. Long life wirewound pots replace the analog pots. We supply a clear set of instructions. Two holes need to be drilled into the side rail of the Control Room faceplate. Hardware is supplied to mount the PC board and the new wirewound pots to the front panel. A simple 3 wire cable picks off +-16 volts to power the module. Four wires are installed at E points for the Headphone and Monitor signals. The conversion takes less than an hour.


RMX-12 connector kit
Qty: 1

This kit has all the Molex housings and male crimp pins to install a RMX-12 console


RMX-20 connector kit
Qty: 1

This kit has all the Molex housings and male crimp pins to install a RMX-20 console.


Qty: 1

This kit contains all the Molex housings and male crimp pins to install a RMX-28 console.


Browse the inventory index below for everything you need. And be sure to return to see the latest items as our site is updated weekly.

Our goal is to exceed your expectations.

News Updates


If you would like a large preview image of any product listed on this web site, please request it by e-mail and it will be sent to you as an e-mail attachment.

*Available inventory is subject to change. We do our best to keep the online inventory current, yet some items shown may be out of stock due to prior sales.
<< Back Home

Mooretronix - Broadcast & Industrial Electronics
5311 South Green Avenue
Fremont, Michigan 49412
Call today at 231-924-7818 or 800-300-0733 or